MW7 Alarm Clock Camera Setup (AP Mode)

Important note:
Before you start the setup, disable the phone's mobile data first.
This helps to make the setup faster and smoother.
(You can re-enable mobile data after the setup is complete).
Play Video

You can watch this video tutorial from this link on your PC/phone web browser:
https://wiwacam.com/mw7-a-en

IMPORTANT:
Note1: The camera supports two setup methods. If the camera does not work via the above described procedure

can be set up, please try the second way, here is the link to the video tutorial:
https://wiwacam.com/mw7-s-en

Note2:If you encounter any problems during setup, here is the troubleshooting and solution:

https://wiwacam.com/ap-faq-en

Note3: To run the camera without WLAN or Internet, for example, to monitor e.g. a car or an allotment garden, check this link: 
https://wiwacam.com/no-wifi-en

Procedure in video:

– Remove the front panel of the camera.
open the back cover(using the reset pin in the box).

– Plug the camera into a power outlet. Put the ON/OFF button to ON.

– Wait for 30 to 40 seconds, see the time display on camera starts to rotate in a circle (rotating in circle indicates camera is ready for setup)

– Launch WIWACAM app, tap “+” on the top right, select ‘MW7 Pro’, tap “other option” on the top right to select AP mode.
Follow the instructions in the app

– The app will prompt you to connect your smartphone to the camera’s Wi-Fi.
Go to the smartphone’s WLAN settings and connect it to the camera’s WLAN (starts with “WIR-“).

– The app will find the camera. After that, it will ask you to set a name and a secure password for the camera.

– Select your WLAN to which you want to connect the camera and enter the WLAN password.
Wait a few minutes, the setup is complete.

– Camera Setup done!

– Install the back cover back to the camera.
Install the front cover with glass back to the camera.
Connect camera to USB power.